Follett VERSION 6.00 Manual de usuario descargar pdf (Pagina 669)

100

101

04/04 669Appendix E Using a PHD+, PHD+ II, or PHD Laser+

To charge the batteries for your PHD unit, make sure the device is turned off.

Connect the battery charger to the port (location and type of end vary from unit

to unit). Plug the battery charger into an electrical outlet.

Charge all units for 16 hours initially. Thereafter charge them for a minimum of 8

hours only when the LOW BATTERY message appears. Remove the battery

charger from the outlet, and then disconnect the charger from the PHD.

Installing a rechargeable battery pack

If you change from alkaline batteries to NiCd batteries in a PHD+ or PHD+ II, no

modification of the unit is needed.

If you purchased the rechargeable battery pack for the PHD Laser+, please follow

these instructions to install it:

1. With the unit turned off, remove the hand strap by twisting the clip at the

lower end. Then, remove the battery cover.

2. Locate the white wiring harness on the lower left side. Attached to the

harness are two wires connected to the battery and one that forms a loop.

Grasp this loop and pull up. The harness will unplug from the unit.

3. Remove the harness, wires, and 9volt battery from the unit.

4. Carefully remove the gluedin foam insert that surrounded the battery.

5. Place the rechargeable battery pack into the unit, making sure that it is right

side up. Check to see that the battery pack is making connection with the

contacts located in the bottom of the scanner.

Note: Do not remove the wrapping from the batteries.

6. Replace the battery cover and hand strap.

7. Connect the recharger to the bottom of the unit and recharge the unit for a

minimum of 14 hours. The packs do not come charged from FSC. When the

unit is recharging, the red light located in the middle of the keypad should be

lit. This indicates that the unit is charging.

8. Keep the wiring harness and the foam insert. You may use it later if you wish

to convert back to alkaline batteries.

Backup power

The PHD+ contains a lithium backup battery. When the NiCd batteries are

removed, the lithium battery has a life of about 1000 hours (16 days) if the device

is not turned on. We recommend you replace the lithium battery every five years.

Note: For information on replacing the lithium backup battery, contact the Follett

Returns Department.

The PHD+ II and PHD Laser+ contain a super capacitor (supercap). The super

capacitor provides backup power to protect the application program only long

enough for the NiCd batteries to be charged. By itself, it can only sustain the

PHD+ II/PHD Laser+ for 20 minutes of continuous use.

1 2 ... 664 665 666 667 668 669 670 671 672 673 674 ... 729 730

Comentarios a estos manuales

Sin comentarios

Follett VERSION 6.00 Manual de usuario Pagina 669

Comentarios a estos manuales