Follett C/E25HT400A/W Manual de usuario descargar pdf (Pagina 24)

Ice transport tube replacement

models C/E25FB400A/W, C/E50FB400A/W, C/E25CR400A/W, C/E50CR400A/W

1. Remove top and rear access panel from dispenser (lower front panel in freestanding unit).

2. Disconnect existing ice tube from engaging pin on transport tube bracket in ice storage bin and pull down

through dispenser chase.

3. Disconnect opposite end of tube from icemaker.

4. Run end of new ice transport tube with 5mm (3/16") hole through ice transport tube knockout (Fig. 5G) in

back of dispenser or through counter into bottom of dispenser, being careful to avoid any bends with less

than 153mm (6") radius.

5. Insert tube in internal chase in rear inside corner of dispenser (left side as you face dispenser) and push up

into storage area.

6. Push the 5mm (3/16") hole near end of tube into pin on ice tube bracket (see drawing below)

Steps 7-8 for units with Satellite-fill icemakers only

7. Install supplied insulation to run of transport tube required for your site, leaving approximately 51mm (2") of

tube exposed at free end.

8. Check that insulated tube runs continuously from icemaker to dispenser with no dips.

All units

9. Slip supplied hose clamp onto tube and push tube onto exit port of evaporator.

10. Fasten tube on port with hose clamp, being sure that clamp is positioned on evaporator side of nozzle flange.

11. Tighten clamp.

Correct installation of ice transport tube is critical to Satellite-fill icemaker performance.

Replacement ice transport tubes for remote icemakers must be insulated and run continuously

from icemaker to dispenser with no dips or bends with a radius of less than 153mm (6").

engaging pin

5mm (.187) ice tube hole

ice hose mounting bracket

capillary tube

ice tube

25mm

(1")

26mm

(1")

Section A – A

5mm (.3/16")

dia. hole

Only use tubing supplied by Follett Corporation. Do not twist hose when securing evaporator.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Follett C/E25HT400A/W Manual de usuario Pagina 24