Follett HCD1400R Manual de usuario descargar pdf (Pagina 21)

Fig. 22

11. Reconnect transport tube to louvered

docking assembly.

12. Plug sensor in at the electrical box.

13. Reconnect vent tube to the shuttle housing

as shown.

Apply

petrol-gel

Fig. 23

14. Apply a coat of petrol-gel compound to the auger

shaft.

15. Install gearmotor, making sure that insulation is

properly seated between gearmotor and main

housing as shown.

16. Firmly tighten four gearmotor bolts in place.

17. Insert a bolt into the auger shaft and finger tighten.

removed for clarity

Note: Shuttle housing

Fig. 21

6. Orient auger shaft with keyway in the

upward position.

7. Force main housing into position against evaporator

and place 1/4" (7mm) diameter Phillips screwdriver

into hole in the auger shaft.

8. Replace V-band clamp as shown.

9. Replace nut on V-band clamp and tighten.

10. Remove screwdriver.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Sin comentarios

Follett HCD1400R Manual de usuario Pagina 21